Publicidad
Idiomas disponibles
Idiomas disponibles
Contents of Carton
1 - Air Compressor
1 - Parts bag containing:
1 - Operator's Manual
1 - Parts Manual
4 - 5/8" Washers
Tools Required
for Assembly
1 - 9/16" socket or open end wrench
Electric drill
Unpacking
1.
Remove all packaging.
It may be
necessary to brace
or support one side of the outfit
when removing the pallet because
the air compressor will have a
tendency to tip.
2.
Remove and discard the (4)
screws and washers holding the
compressor to the pallet.
3.
With the help of another person
carefully remove air compressor
from pallet and place on a level
surface.
HOW TO SET UP YOUR
UNIT
Location
of the Air Compressor
*
Locate the air compressor
in a
clean, dry, and well ventilated
area.
•
Located the air compressor
at
least 12" away from the wall or
other obstructions
that will
interfere with the flow of air.
•
Locate the air compressor
as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE: Long lengths of electrical
wiring could cause power loss to
the motor.
•
The air filter must be kept clear
of obstructions
which could
reduce air flow to the air
compressor.
Anchoring
of the Air
Compressor
_
Excessive
Vibration
can weaken the air
tank and cause an explosion. The
compressor must be properly
mounted.
The air compressor
MUST be bolted
to a solid, level surface.
Hardware needed:
4-
Concrete anchors
4 - 3/8" Lag screw to fit
concrete anchors (not
supplied)
4 - 5/8" Washer (found in parts
bag) shims (if needed)
1.
Place the air compressor
on on a
solid, level surface.
2.
Mark the surface using the holes
in the air compressor feet as a
template.
3.
Drill holes in the surface for the
concrete anchors. Install
concrete anchors.
3/8" Lag
Screw
(not supplied)
5/8" Washer
(supplied)
Surface Line
Shim Under
Washer
Concrete Anchor
(not supplied)
(not supplied)
4.
Line-up holes in surface with
holes in air compressor feet.
D29312
10- ENG
Publicidad
