Publicidad
ce
enance
MPS750S-2
om
4. Limpie los residuos de los raíles de la espada (13) con un destornillador, una
espátula, un cepillo de alambre u otra herramienta similar. Esto mantendrá abiertos
o
los conductos de aceite para suministrar la lubricación adecuada a la espada (13)
ng
y a la cadena (14) (Fig. 39).
5. Compruebe si el raíl de la espada presenta desgaste. Sostenga una regla (de
borde recto) contra el lateral de la espada y las placas laterales de corte. Si existe
una holgura entre la regla y la espada, el raíl de la espada es normal. Si no hay
holgura (la regla queda al ras contra el lateral de la espada), el raíl de la espada
está desgastado y debe sustituirse por uno nuevo del mismo tipo (Fig. 40).
asily
s of
h an
6. Compruebe la cadena por si presentara desgaste y daños. Si es necesario, sustitúyala.
Un usuario experimentado puede afilar la cadena si está roma (consulte la sección
"Afilado de la cadena" a continuación).
7. Vuelva a colocar la cadena (14) y la espada (13) como se describe en la sección
"Montaje".
MPS750S-2-3663602627685-MAC-ES-V01.indd 47
MPS750S-2
MPS750S-2
4. Clear residue from the rails on the guide bar (13) by using a
screwdriver, putty knife, wire brush or other similar tool. This will
keep the oil passages open to provide proper lubrication to the bar
4. Clear residue from the rails on the guide bar (13) by using a
(13) and chain (14) (Fig. 39).
screwdriver, putty knife, wire brush or other similar tool. This will
keep the oil passages open to provide proper lubrication to the bar
(13) and chain (14) (Fig. 39).
Fig. 39
Fig. 39
5. Check the guide bar 'rail' for wear: Hold a ruler (straight edge)
Fig. 39
against the side of the guide bar and 'cutter side plates'. If there is
a gap between the ruler and guide bar the guide bar 'rail' is normal.
5. Check the guide bar 'rail' for wear: Hold a ruler (straight edge)
If there is no gap (ruler flush against the side of the guide bar) the
against the side of the guide bar and 'cutter side plates'. If there is
guide bar 'rail' is worn and needs to be replaced with a new one of
a gap between the ruler and guide bar the guide bar 'rail' is normal.
the same type (Fig. 40).
If there is no gap (ruler flush against the side of the guide bar) the
guide bar 'rail' is worn and needs to be replaced with a new one of
the same type (Fig. 40).
Fig. 40
Fig. 40
6. Check the saw chain for possible wear and damages. Replace it
Fig. 40
with a new one if required. Experienced user can sharpen a dull
saw chain (see section "Saw chain sharpening" below).
6. Check the saw chain for possible wear and damages. Replace it
7. Refit the saw chain (14) and the guide bar (13) as described under
with a new one if required. Experienced user can sharpen a dull
"Assembly".
saw chain (see section "Saw chain sharpening" below).
7. Refit the saw chain (14) and the guide bar (13) as described under
"Assembly".
Care and maintenance
Care and maintenance
Cuidado y mantenimiento
EN
47
47
4/13/2018 11:03:30 AM
Publicidad
