Parts & Features
See figures below for reference.
Quick Connect
Offers a quick release feature for
attaching and removing
the air hose.
'_ Regulator
Gauge
"]
Indicates the outgoing air pressure I
to the tool and is controlled by
|
the regulator.
J
Pressure
Relief Tube
Regulator
1
The air pressure coming from the air tank is controlled by the
regulator. To increase the pressure turn the knob clockwise and to
decrease the pressure turn the knob counterclockwise.
Pressure Relief Valve
"/
/
The pressure relief valve located on the side of the pressure|
switch, is designed to automatically
release compressed air l
when the air compressor reaches cut-out pressure. The
|
released air should only escape momentarily and the valve |
should then close.
J
Pressure
Switch
This controls the power to the motor and also the cut-in/
cut-out pressure settings. This switch serves as the
AutolOff positions for the unit.
Tank Pressure Gauge
Indicates the reserve air pressure in the tank.
Air Intake Filter
Provides clean air to the pump and must
always be kept free of debris. Check on a
daily basis or before each use.
Tank Safety Valve
Used to allow excess tank pressure to escape
into the atmosphere. This valve should only
open when the tank pressure is above the
maximum rated pressure.
Oil Fill Cap
Oil Sight Gauge
Outlet Tube
Tank Drain Valve
Used to drain condensation from the air tank.
Located at bottom of tank.
I
Check Valve
1
When the pump is not in operation the valve closes to retain air
pressure inside the tank. An internal component.