Publicidad
Idiomas disponibles
Idiomas disponibles
BR N
MODELS
QP430SS
,, QP436SS
,, QP442SS
INSTALL THE HOOD
_
ARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
WIRING BOX
COVER
ELECTRICAL
POWER
CABLE
KNOCKOUT
J
El
Remove Electrical
Wiring Box Cover from inside
of hood and appropriate Electrical
Power Cable
Knockout
from top or back of hood.
Page 7
CONNECT
THE WIRING
GROUND
SCREW
El
HOUSE POWER CABLE
Connect House Power Cable to range hood wiring -
BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to Ground Screw. Replace electrical wiring
box cover.
FOR 30" MODEL ONLY:
Replace rubber bushing, re-connect left-hand light panel
electrical connector, and re-attach light panel with (2)
screws removed in Step 6.
Re-attach Bottom Pan with 6 Screws removed in Step 5.
Install aluminum filters.
HOWTO CHANGE LIGHT BULBS
o I
HOUSE
POWER CABLE
[_
Run House Power Cable between service
and hood
panel
location. Attach power cable to hood using appropriate clamp.
[_
Hang hood from (4) mounting screws driven
into
part-way
cabinet locations (shown in illustrations under "PREPARE
HOOD LOCATION"). Mounting screws are included in
parts bag. Slide hood back towards wall until mounting
screw heads are engaged in narrow end of keyhole slots
in top of hood. Tighten screws securely. Add 5th mounting
screw in center hole in hood and tighten securely.
[_
Connect ductwork
hood and
duct
make
to
use
tape to
joints secure and air-tight. Make sure the damper/duct
connector enters the ductwork and that the damper opens
and closes freely.
CAUTION: Bulbs may be hot. Refer to bulb
packaging for further
information.
Install (4) _en
Bulbs (included with hood). Use 120 V, 50
W, shielded halogen bulbs - MR16 with GU10 base.
NOTE: Suction
CupTool
(included with hood) can be used to
install and remove light bulbs.
Align pins on bulb with large diameter opening on socket, then
push bulb in towards hood and rotate clockwise until firmly
seated.
The position of the bulb socket (depth) is adjustable and may
require adjustment when:
a) certain brands of bulbs are difficult to install.
b) the bulb protrudes too far below the light panel.
Publicidad
