Glacier bay BZ501100BN Guía De Uso Y Cuidado

TOOLS REQUIRED
Phillips Flathead
screwdriver screwdriver
Level Template
Installation
1
Determining the mounting
location
Tape the template to the wall with masking
tape and ensure it is completely level.
Use a level to determine the location where
you want to install your accessory.
USE AND CARE GUIDE
TOWEL BAR
Electric drill Claw
hammer
Masking tape
2
Drilling the pilot hole
Pre-drill a pilot hole with a small drill.
Safety Information
If installing into ceramic tile, before attempt-
ing to drill through ceramic tile, the following
must be done:
Using a center punch, very lightly and care-
fully tap the spot where you wish to drill to
break the shiny glass portion of the tile.
HARDWARE INCLUDED
AA-Mounting bracket x2
CC-Set screw x2
3
1
Please contact 1-855-HD-GLACIER for further assistance.
Item #000-000
000-000
Model #BZ501100BN
BZ501200BN
OMSID #305556529
305556521
BB-Mounting screw x4
DD-Solid wall anchor x4
Installing the brackets in ceramic
tile
Drill 1/4 in. based on the pre-drill pilot hole.
Tap 1/4 in. solid wall anchors (DD) into the wall
with a hammer until flush with the wall.
Align the mounting brackets (AA) with installed
solid wall anchors (DD) and secure with the
mounting screws (BB).
DD
DD
AA
HOMEDEPOT.COM/GLACIERBAY
BB