Descargar Imprimir esta página

Kenmore 106 Manual De Uso Y Cuidado página 6

Ocultar thumbs Ver también para 106:

Publicidad

Idiomas disponibles

Idiomas disponibles

Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator
into its final location,
it is
important
to make sure you have the proper
electrical
connection:
@
@
@
Recommended
Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused,
grounded electrical supply is required. It is recommended
that a separate circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning,
or removing a light bulb, turn the Thermostat Control (or
Refrigerator Control depending on the model) to OFF and
then disconnect the refrigerator from the electrical source.
When you are finished, reconnect the refrigerator to the
electrical source and reset the Thermostat Control (or
Refrigerator Control) to the desired setting.
Electrical
Shock Hazard
Disconnect power before removing doors.
Failure to do so can result in death or
electrical shock.
NOTE: Before removing doors, open both doors and
remove base grille (see the "Base Grille" section).
Tools Needed:
1/4-inch hex-head socket wrench and sA6-inch hex-head
socket wrench.
1, Unplug refrigerator or disconnect power.
2, If you have a dispenser (ice or water), disconnect water
line (behind base grille).
Remove hose from clip.
Disconnect union nut and slide it back onto tube.
Remove metal insert from tube.
Remove union nut and spring.
\
/
6

Publicidad

loading