Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly
before proceeding.
• CAUTION - Unplug the
refrigerator.
To eliminate
the danger
of electric
shock
during
installation,
you must unplug
the refrigerator
from
its electrical
outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
Pliers
screwdrivers
1/4" Nutdriver or adjustable wrench
Sharp knife
i-i-I PREPAREFOR INSTALLATION
, Remove and discard the large white plug from the
rear freezer wall.
, Remove the outlet cover with u flat-blade screwdriver.
[-3-] I NSTALL THE ICEMAKER FILL CUP
Install the icemaker
fill cup (side-mounted)
(15) into the
icemaker as shown.
m PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power
cord plug into the socket, making sure that the prongs
and holes are matched.
Press the plug firmly
into the
socket. Lock the plug in place by clipping the restraints
onto each side of the plug. Make sure the restraints click
into place. Make sure the power cord is still in the hook on
the back of the icemaker.
Hook
[_] MOVE FEELER ARM TO THE STOP
POSITION
Move the feeler arm to the STOP (up) position. Leave the
feeler arm in the STOP position until the refrigerator
is
connected
to the water
supply to prevent
premature
operation.
(Appearance
may vary)
D MOUNT THE ICEMAKER
, Lift the icemaker
so the
fill tube
extension
(8) fits
in the fill cup opening
(C).
Hang the icemaker
on the
two mounting
screws (A).
Hake sure:
.....
• The power
cord
is still
firmly
in the socket.
, The fill tube extension
(8) is still in the fill cup opening,
(Check the rear of the refrigerator
to make sure the
fill tube has not been pushed out of the back of the
refrigerator.)
,The
icemaker
mounting
screws
are
located
in the
uppermost
position
of the mounting
slots.
, The icemaker
is level.
THEN TIGHTEN THE ICEMAKER MOUNTING SCREWS
SECURELY,
13
Publicidad
