Publicidad
Idiomas disponibles
Idiomas disponibles
A
IMPORTANT SAFETY INSTRUCTIONS - Please Read and SAVE this information
Read these installation instructions completely and
follow them carefully. They will save you time and
effort and help to ensure safety and optimum dishwasher
performance.
if the dishwasher is installed in a location that experiences
freezing temperatures (e.g., ina holiday home), you must
drain all the water from the dishwasher's interior. Water
system ruptures that occur as a result of freezing are NOT
COVERED
BY WARRANTY.
IMPORTANT
*
The dishwasher drain hose must be installed with a
portion of it at least 20" (508mm) above the cabinet
floor; otherwise the dishwasher may not drain properly.
¢
This dishwasher is intended for indoor residential use
only, and should not be used in commercial food service
establishments.
OTHER IMPORTANT
INFORMATION
Before installing the "L-shaped supplied countertop
mounting brackets (select models), decide which method
will be used to secure the dishwasher into its opening. Once
these mounting brackets are installed on the dishwasher,
removing them is difficult and will damage the mounting
brackets and the dishwasher.
Electrical Supply Cable - Minimum #14 AWG
2 conductor, 1 ground, insulated copper
conductors rated 75°C (167°F) or higher.
*
This dishwasher is designed to be enclosed on the top
and both sides by cabinetry.
*
NEW
INSTALLATION - If the dishwasher is a new
installation, most of the work must be done before the
dishwasher is moved into place.
*
REPLACEMENT - If the dishwasher is replacing another
dishwasher, check the existing dishwasher connections for
compatibility with the new dishwasher, and replace parts
as necessary.
*
This appliance has been found to be in compliance with
CAN/CSA-C22.2 No. 167/UL 749. It is the responsibility
of the owner and the installer to determine if
additional requirements and standards apply in specific
installations.
*
Not for outdoor use.
Inspect the Dishwasher
After unpacking the dishwasher and prior to installation,
thoroughly inspect the dishwasher for possible freight or
cosmetic damage. Report any damage immediately by
calling 1-800-4-MY-HOME. Cosmetic defects must be
reported within 30 days of installation.
NOTE:
Do not discard any bags or items that come with
the original package until after the entire installation has
been completed.
MATERIALS NEEDED
Shut-off
valve
and
fittings
appropriate
for hot water supply
line (copper tubing/
compression fitting, or braided hose).
Hot Water Supply Line - Minimum 3/8"
(0.95cm) ©.D. copper tubing, PEX, or metal
braided dishwasher supply line.
UL listed conduit connector or strain relief
is required if you attach the field wiring
directly to the terminal block.
Shut-off valve and fittings appropriate for hot
water supply line (copper tubing/compression
fitting, or braided hose).
Four screws to mount the junction box
Publicidad
