GE GFWS1705 Manual Del Propietario E Instalación página 22

Instollotion Instructions
WATER SUPPLY REQUIREMENTS
Hot and cold water faucets MUSTbe installed within
42 inches (107 cm) of your washer's water inlet. The faucets
MUSTbe 3/4" (1.9cm) garden hose-type so inlet hoses can
be connected. Water pressure MUSTbe between !0 and 120
pounds per square inch. Your water department can advise
you of your water pressure.The hot water temperature
should be set to deliver water at 120° to !40°F (48°-60°C).
DRAIN REQUIREMENTS
!. Drain capable of eliminating 17 gals (64.3 L)
per minute.
2. A standpipe diameter of !-!/4" (3.!8 cm) minimum.
3. The standpipe height above the floor should be:
Minimum height: 24" (6! cm)
Maximum height: 96" (244 cm)
I--
96"
(244 cm)
Max.
BACK
T
24"
(61 cm)
Min.
NOTE:The drain hose attached to the washer can reach
a S8"(!47 cm) high standpipe. For a higher standpipe,
contact an authorized parts distributor.
22