GE GFWS1705 Manual Del Propietario E Instalación página 9

GEAppliances.com
Signal._]) Cycle Signal
Usethe Signal pad to change
the volume of the end of cycle signal.
Pressthe pad until you reach
the desired volume.
or
Lock Controls Hold 3 Seconds To
Hold 3 Sec Lock/Unlock Controls
(depending on model)
Lock Controls or Lock
(depending on model)
You can lock the controls to prevent
any selections from being made. Or
you can lock or unlock the controls
after you have started a cycle.
Children cannot accidentally start the
washer by touching buttons with this
option selected.
To lock the washer, press and hold the
Lock Controls or Lock button for 3
seconds.
To unlock the washer controls, press
and hold the Lock Controls or Lock
button for 3 seconds.
A sound is made to indicate the lock/
unlock status.
The indicator light above the button
will illuminate when the controls are
locked.
NOTE: The Power button can still be
used when the machine is locked.
Start / Pause
Sta rt
Pause/Add o Garment
Add a Garment
®
(depending on model)
Start/Pause-Add A Garment
Press to start a wash cycle. If the
washer is running, pressing it once will
pause the washer and unlock the door.
It will take a few seconds for the door
to unlock after pressing Pause. Press
again to restart the wash cycle.
NOTE: If the washer is paused and
the cycle is not restarted within 15
minutes, the current wash cycle will be
cancelled.
NOTE:In some cycles the washer will
drain first, then unlock the door when it
is paused.
NOTE:The washer performs automatic
system checks after pressing the Start
button. Water will flow in 45 seconds
or less.You may hear the door lock
and unlock before water flows; this is
normal.
(appearance will vary
and not all features
on all models)
Display
Displays the approximate time
remaining until the end of the cycle.
NOTE:The cycle time is affected by
the water pressure in your home and
the balance of the load in the washer.
You may see the time remaining on
the display increase to accommodate
a slower spin speed to handle
unbalanced loads.
On some models, cycle status is also
displayed and certain features such
as Delay Wash or Steam are shown
indicating they have been selected.