GE 22 Manual Del Propietario E Instalación página 10

About crisper removal
Not all features are on all models.
Crisper Removal
To Remove:
These drawex5 can be remoxed easily b)
lifting up slighfl) while pulling the drawer
past the stop location.
When the door cannot be fully opened,
rein eve the dra wet fi_rth est fl'om the door
fixst. Make sure the drawer closest to the
door is fifllv closed. There is a latch at the
front of the center slide rail. Push down on
the latch and slide the center slide rail, to
which the drawer is attached, a_;ly fl'om the
door Renlove the drawer
About the automatic icemaker.
A newly-installed refrigerator may take 12-24 hours to begin making ice.
Power
Switch Icemaker
!
PowerLight
er Arm
Power switch model
Fee!er A rm in (up)position
the ON (down)
position
Feelerarm model
Automatic Icemaker
(on some models)
The icemaker will produce seven
or eight
cubes (depending on model) per cycle--
appro_mately 100-130 cubes in a 94-hem-
period, depending on fl'eezer compartment
teiilpei'attli'e_ i'ooi/] teiilpei'attli'e_ ntlillber
of door openings and other use conditions.
There are two t)pes oficemake_s: power
switch models and ti_eler am/models.
If the refi-igerator is operated heft)re the
water connection is made to the icemake_,
set the power switch
U) 0 (Off) or move
the
teeler am_ to the
STOP
(up) position.
When the refl-igerator has been connected
to the water sui)i)ly, set the power switch to
the I (on)position or move the teeler am/to
the ON (down) position. On power switch
models,
the green
light
will come on.
You will hear a buzzing sotmd each dine
the icemaker fills with water;
The icemaker will fill Mth water when it
cools to approximately 15°F. A newly-
installed refrigerator may take 12 to 24
houI_ to begin making ice cubes.
Throw awm the first tow batches of ice to
allow the water line to clear
Be sm'e nothing intetTeres xfith the sweep
of the feeler amL
_._]_en the bin fills to the level of the teeler
am_, the icemaker will stop producing ice.
It is nomml fin" several cubes to be.joined
together:
If ice is not used fl'equentl> old ice cubes
will become cloud> tnste stnle and shrink.
On power switch models, the green power
light will blink if ice cubes get stuck in the
icemaket: To correct this, set the power
switch to 0 (off) and remove the cubes. Set
the power switch to ! (on) to restart the
icemake_: _Mter the icemaker has been
turned on again, there will be a delay of
about 45 minutes before the icemaker
I'eStlllleS opeI_ltion.
NOTE: Inhomeswith lower-than-average water
pressure, youmayheartheicemaker c yclemultiple
timeswhenmaking onebatchof ice.
10
Icemaker Accessory Kit
If }our refrigerator did not come ah'eadv
equil)ped with an automatic icemake_;
an icemaker accessma' kit is ax filable at
extra cost.
Check the back of the refrigerator fin"
the specific icemaker kit needed fin.
VOIII"
model.