GE 22 Manual Del Propietario E Instalación página 20

Installation Instructions
REVERSING THE DOOR SWING
(CONT.)
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
]_.emove the center hinge bracket b.v removing
the three screws.
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
You will need to remove the colo>matched cap fl'om
the screw head befl)t'e volt c[lIl I'eIll(we the screw.
Use the edge of a thin flat blade to gently pry the
caps off the screw heads. (A put D' knite works well
fin" this.) Cover the blade with tape to prevent
scratching the paint.
Remove the mullion cover fl'om the left side using
the thin flat blade. Assemble it to the fight side.
Remove the screw fl'om the center left side of the
cabinet. Screw it into the holes on the right side.
Place the center hinge bracket ()vet" the holes at
the center left side of the cabinet. Insert and
tighten the three hmg screws.
Replace the cap by snapping it over the screw with
your finger.
[] TRANSFER DOOR STOPS
On each door, mo_e the metal door stoi_ ti'om the
right to the left.
Moxe any screws fl'om the left to the right.
[] TRANSFER REFRIGERATOR
DOOR HANDLE TO THE RIGHT
To remove the handle: Remove the I)lug button by
carefldly pr)_ng under the edge with a putt)' knife.
Remove the exposed screw holding the handle.
t
Handle Plug
Remoxe the two screws holding the handle to the
top of the door.
LongHandle
Short
Screw
ShortHandle
Hole Handle
\ Plug
Pin
Handle
After removing the handle: Move the small plug
buttons fl'om the top fight side of the door top and
insert them into the holes on the opposite side.
Small P lu,
Buttons
Move the large, I)lu°,_ button fl'om the left edge of the
door and insert it into the hole on the opposite side.
Plug Button
2O