GE 22 Manual Del Propietario E Instalación página 17

Installation Instructions
[] CONNECT THE TUBING TO THE
REFRIGERATOR
NOTES:
• getm'e making tile connection to tile reti'igerator,
be sure tile refl'igerator power cord is not
plugged into tile wall outlet.
• We recommend installing a water filter if w)m"
water SUl)ply has sand or particles that could clog
the screen of the refl'igerator's water wdve. Install
it in the water line near the refrigerator. If using
GE SmartConnect '_ Refl'igerator Tubing kit, you
will need an additional tube (WX08X10009) to
connect tile filter. Do not cut plastic tube to
install filter.
Reillo'_e tile access co_,ei',
Remove tile plastic flexible cap from tile water xalve
(refrigerator connection).
Place tile compression nut and ferrule (sleeve)
onto the end of the tubing as shown, On GE
SmartConnect _'' Refl'igerator Tubing kit, tile nuts
are ah'eadv assembled to tile tubing.
Insert tile end of tile tubing into tile water wdve
connection as thr as possible. While holding the
tubing, tighten tile fitting.
For plastic tubing fl'om a GE Smart(:mmect ''_
Refl'igerator Tubing kit, insert the molded end of
the tubing into the shutoff \;dye and tighten
compression nut tmtil it is hand tight, then tighten
one additional turn with a wrench. Overtightening
Ill'IV Catlse
leaks.
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
Fasten tile tubing into tile clamp provided to hold
it in a vertical position. You may need to PU open
tile clamp.
One of the illustrations below wiU look like the
connection on your refrigerator.
Icemaker Models without Water Dispenser
1/4"Tubing
SmartC_
Tubing
Water Dispenser Models
TubingClamp...
)n Nut
(sleeve)
- Refrigerator
Connection
1/4"Tubir
1/4" Compression N ut,
Refrig
SmartConnect _ Tubing
[] TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten am connections that leak.
Reattach tile access cover.
17