GE 22 Manual Del Propietario E Instalación página 8

About the shelves and bins (cont.).
Sfide-Out Spil/proof Shelf (on some models)
The slide-out spilli)roof shelf allows )ou
Toreplace:
to reach items stored behind othe_. The
special edges are designed to help prexent 0 Place the rear shelf tabs just in fl'ont of
' ' the central notches on the shelf frame.
spills from dripping to lower shelxes.
To remove: _
Slide the shelf in until the central tabs
are slightly behind the front l)a_;
Remove all items fl'om shelfl
Slide the shelf out tmfil it stops.
0 I,iJt the fl'ont edge ot the shelf until the
central tabs are above the fl'ont l)a_;
0 ())nfinue pulling the shelf fi)r_n'd
until it can be removed.
I,ower the sheff into place tmtil it is
horizontal and slide the shelf in.
Make sure that the shelf sits fiat after relbsta//at/on
and doesn't move freely from side to side.
Make sure you push the shelves all the way in
before youclose the door
,Finger h old
,,Snugger
Adjustable Bins on the Door
A(!iustable bins can easily be carried fi'om
I'etiJgeI':ltoI" to woYk _lI'e_l,
To remove: i,ifi bin straight
ui), then
pull out.
To replace or relocate: Engage the bin in the
molded supports of the (loox; and push in.
Bin will lock in place.
The snuggerhelps prevent tipping, spilling
or sliding of small items stored on the door
shelf. (h_iI) the finger hold near the rear of
the snugger and move it to fit w)ur needs,
Non-Adjustable Shelves on the Door
To remove: Lift the shelf straight up, then
pull out.
To replace:Engage the shelf in the molded
SUl)l)orts on the door and push down.
It will lock in place.
Freezer Tilt Out Bin (onsomemodels)
Push the button as you tilt out the bin.
To
remove: Hold the sides of the bin and
lift it straight uI), then ptfll out.
To
replace:Engage
the ends oI the bin in
the molded SUpl)orts on the door and
push down. It will lock in place.
NOTE." Do not overload the b/n.