Friedrich SS08 Manual De Instrucciones página 5

920-090-05 (12-05)
How to operate your Friedrichroom air conditioner
To adjust temperature
[60°F (16°C) to 90°F (32°C)]
@ COOLER- Touch COOLER to see setting,touch again
to change.
©
®
WARMER - Touch WARMER to see setting, touch
again to change.
Touch °F/°C to show desired temperature in Fahrenheit
or Celsius.
To adjust fan speed
@ Touch SPEED 1-4 to see current setting. Touch again
to change speed. F1 is the lowest setting (SLEEP
SETTING), F2 is low speed (LOW), F3 is medium
speed (MED), F4 is high speed (HIGH).
Toactivate smart fan
@ Touch SMART FAN (light on). Smart Fan will adjust
the tim speed automatically to maintain the desired
comtbrt level. For example, if the outside doors in your
home are (>pen for an extended period of time, or more
people enter a room, Smart Fan may adjust to a higher
fan speed to compensate tbr the increased heat load.
This keeps you from having to adjust the tim speed on
your own. Smart Fan cannot be activated in the FAN
ONLY mode.
To deactivatesmart fan
@ Touch SPEED 1-4_and select your desired tim speed.
To set hour clock
(Q) Press SET HOUR CLOCK once to see the current
clock setting. Continue pressing the button until
the hour closest to the actual time appears in the
display. MAKE SURE YOU SET A.M. AND RM.
PROPERLY. A light will appear in the upper left
corner of the display when the hour is p.m.
Minutes will NOT show on display.
To set the timer
NOTE: SET HOUR CLOCK before attempting to set
timer functions.
You can set the A/C START and A/C STOP timer a
minimum of one hour apart and a maximum of twenty-
three hours apart.
@ TIMER STOP - Press the A/C STOP button and hold
until the hour you want the unit to shut off appears in
the display (A.M. or RM.). The stop time for cooling
will then be set.
PM
m
QumT aster,
PROGRfllTimflgL[
Power
Mode
Temperature
Fan
Press to reset
Figure 4
@
START TIME - Press A/C START to view the current
start time for cooling. Continue pressing until the hour
you want the unit to start appears in the display (A.M.
or RM.). The start time for cooling will then be set.
Press the TIMER ON/OFF button once to activate
(light on) the timer function. Touch TIMER ON / OFF
again (light off) to cancel the timer function if you so
desire. Once the on and off times have been selected,
they will remain in memory, and cycle daily until
changed.
NOTE: If unit is unplugged or power is interrupted, the
SET HOUR CLOCK button must be reset or the TIMER
ON/OFF functions will not work.
Automatic component protection
Your unit is equipped with Automatic Component
Protection.
To protect the compressor of the unit, there is a three minute
time delay if you turn the unit offor if power is interrupted.
The tim will not be affected.
Also, if you switch from COOL mode to FAN ONLY, and
switch back to COOL mode, there is a three minute delay
before the compressor comes back on.