Publicidad
Idiomas disponibles
Idiomas disponibles
9.
Transport
1.
Turn the power tool off before it is transported and
disconnect it from the power supply.
2.
Always carry the electric tool with at least one
other person. Carry the power tool to the machine
bed (12).
3.
Protect the power tool against knocks, jolts and
strong vibrations, e. g. when it is transported in
motor vehicles.
4.
Secure the power tool against tilting and sliding.
5.
Never use the protective devices for handling or
transport.
10. Cleaning and maintenance
m Warning!
Prior to any adjustment, maintenance or service work
disconnect the mains power plug!
General maintenance measures
Wipe chips and dust off the machine from time to time
using a cloth. In order to extend the service life of the
tool, oil the rotary parts once monthly. Do not oil the
motor.
When cleaning the plastic do not use corrosive prod-
uct.
Maintenance
There are no parts inside the machine which require
additional maintenance.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: wood turning chisel
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
11. Storage
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
28 | GB
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
12. Electrical connection
The installed electric motor is connected and is ready
to work. The connection complies with the relevant
VDE and DIN regulations. The customer-side mains
supply and the used extension line must meet these
regulations.
Defective electric connection lines
Often, insulation damages occur on electrical connec-
tion lines.
Causes are:
• Drag marks if connection lines are led through win-
dow or door clearances.
• Kinks due to improper attachment or routing of the
connection line.
• Cuts caused by running over the connection line.
• Insulation damages caused by pulling the connec-
tion line out of the wall socket.
• Fissures caused by the ageing of the insulation.
Such defective electric connection lines must not be
used and are hazardous due to the insulation damag-
es.
Regularly check the electrical connection lines for
damages. Please make sure that the connection lines
are disconnected from the mains supply during the
check.
Electrical connection lines must comply with the rele-
vant VDE and DIN regulations. Only use connection
lines labelled with H05VV-F.
The labelling of the connection cable with the type
specification is required.
AC motor
• The mains voltage must be 220 - 240 V~.
• Extension cables up to 25 m in length must have a
cross-section of 1.5 mm².
Connections and repairs to the electrical equipment
may only be performed by a qualified electrician.
If you have any queries, please provide the follow-
ing information:
• Current type of the engine
• Data from the machine type plate
• Data from the motor type plate
www.scheppach.com
Publicidad
