Publicidad
Idiomas disponibles
Idiomas disponibles
14. Troubleshooting
Trouble
Possible cause
Quality of cut is poor. Cutting tool is dull.
Cutting too aggressive cut.
Cutting tool is positioned below workpiece
center line.
Lathe speed too slow
Excessive vibration
Cutting tool is positioned below workpiece
when turning thin
centre line.
workpieces.
Cutting to aggressively.
Excessive vibration
Headstock and/or tailstock improperly
when turning large
located at ends of workpiece.
workpieces or bowls.
Workpiece is unbalanced.
Lathe will not turn
Cord not connected into electrical outlet.
on.
Lathe will not turn
Damaged or faulty power switch and/or
off.
internal wiring.
30 | GB
Solution
Sharpen or replace cutting tool.
Reduce the working pressure.
Lower cutting tool to maximum 3mm above the
centre line of workpiece.
Increase lathe speed
Raise cutting tool to centerline of workpiece.
Use a lighter touch.
Check for proper workpiece centres at head-
stock and/or tailstock.
Trim end of workpiece until workpiece is more
balanced.
Connect to electrical outlet.
Unplug the lathe from its electrical outlet imme-
diately. Do not operate lathe until it is repaired
by a qualified service technician.
www.scheppach.com
Publicidad
