Publicidad
Mop Pad
Remove the mop pad from the mop pad holder. Wash it and let it air dry.
Sensor
It is recommended to clean the cliff sensor and IR receiver sensor every
Cliff Sensor
11
Brush and Side Brush
1. Remove the side brush.
2. Press and hold the clips to remove the brush cover, then remove the
brush, and pull out the brush bearing.
3. Use the cleaning brush to clean.
Press and hold the
clips to remove.
Side Brush
Cleaning the Brush
Cut the hair
Brush Cover
Clip
Brush
Brush Bearing
Remove dirt and debris
Publicidad
