Publicidad
Before Use
1. Remove the protective strips.
2. Install the side brush.
Take out the side brush, and install it onto the position as indicated in
the figure. The side brush is properly installed when you hear a "click".
3. Remove the protective film from the charging
dock and place the charging dock against a wall.
Connect it to the power.
CAUTIONS:
Do not place the charging dock in an area with direct sunlight.
within 1.5 m in front of the charging dock.
4. Charge the robot vacuum.
Place the robot vacuum on the charging dock to charge.
Notes:
It is recommended to fully charge the robot vacuum before using it for the first
The robot vacuum will turn on automatically when it is on the charging dock, and
cannot be turned off while charging.
07
Publicidad
