HSM Primo 2600 Instrucciones De Servicio página 12

6 Operation
WARNING
Before switching the machine on,
make sure that you observe all
safety instructions.
Switching the paper shredder on
• Press rocker switch
Rocker switch locks in place.
Green LED lights.
Paper shredder is ready for op-
eration (standby).
Feed paper
• Insert the paper to be de-
stroyed. See "Technical data"
for sheet capacity.
Automatic start stop control
starts the cutting system auto-
matically.
Paper is pulled into cutting
system and shredded.
When the paper fee ding
opening is free again, the cut ting sy stem au-
to ma tical ly swit ches off af ter app rox. 3 sec.
and returns to standby.
Shredding CDs, credit cards and
disks (see "Proper Use")
WARNING
Depending on the type of material,
splinters could be produced when
shredding CDs. For this reason,
wear protective goggles.
Insert CD/credit card/disk in centre of the
feed opening.
Swit ching paper shredder off
• Tap rocker switch
Switch returns to ze ro po si ti on.
12
7 Troubleshooting
Paper jam
You have fed in too much paper.
Notice
nately forwards/backwards (
unit could be damaged.
.
Shredded material container full
Notice
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
Door open
For all other malfunctions, before calling
customer service please check
– if the motor was overloaded
Let the shredder cool down for approx.
15 – 20 mins. before using it again.
– if the light barrier is soiled with paper
dust.
.
Clean the light barrier in the paper feed
using a dry brush or cloth.
Primo 2600
english
Do not press rocker switch alter-
• Press rocker switch
Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch
• Feed in pa per successively.
Red LED lights.
Paper shredder switches off.
Empty the cut material container,
• Switch equipment off. To do this
tap rocker switch
• Remove full shredded material
bag and insert new bag.
Red LED lights.
Paper shredder switches off.
• Check whether front door is
closed properly.
- ). Cutting
.
.
.
09/2011