36
7
Inspection / Mainte-nance
7.1 Maintenance Plan
What?
When?
When
Cleaning
necessary
Every 250
Check Bushes
hours
Check oil level
Yearly
top up
Hydraulic oil
-
change
Inspect oil
Yearly
hoses
7.2 Cleaning
Danger
Secure that the machine is out
of use
Clean
• your machine regularly
• especially the stickers (picture sym-
bols) on the machine.(when the stickers
are no longer readable please order
new ones, order num-ber see spare
parts lists)
• working areas of the rollers
7.3 Mechanical
The machine is delivered with mainte-
nance free bushes. Therefore the bushes
only have to be checked regularly (250
working hours) for wear.
WARNING!
Maintenance and repair work only permitted on a table without a
load.
For all cleaning, maintenance, and repair work within the lifting
mechanism, the table shall be lowered ontothe inspection support.
Utilizzare solo parti di ricambio originali del produttore.
Solo gli specialisti sono autorizzati a lavorare sull'impianto idrau-
lico e meccanico.
KT100_KT100XT_(0970M00100)_R1_UN_00
7.4 Maintenance of the hydrau-
Description
7.2
7.3
7.4
7.4
7.9
This machine is filled with bio-oil on
synthetic base
This oil is not mixable with water.
The biological removable hydrau-lic-oil
is mixable with mineral-oil, but then it will
loosen his biologi-cal removability.
The following or equivalent can be used:
ELF XPD 98064 (in this machine)
lics
Danger
Hydraulic oil can cause irritation
and skin rashes. Avoid prolon-
ged skin contact and wash the
skin thoroughly after contact.
Wear protective clothing! (see
chapter 1.8)
Protect the environment:
The handling and disposal of
min-eral oils is covered by laws.
Dis-pose of old oil at an autho-
rised disposal unit. Information
can be found from the respon-
sible au-thority. Be careful not
to spill any hydraulic oil. Make
precautions to catch any spilt
oil oil resistant co-vers, drip tray
etc.)