Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Review this table to find do-it-yourself
solutions
for minor performance
problems. Any service
needed, other than those described
in this owner's manual, should be performed
by a Sears
service representative.
WARNING
Electrical Shock Hazard
Disconnect
electrical
supply before servicing
or cleaning the unit. Failure
to do so could result in electrical
shock or personal
injury.
Cleaner won't run.
Poor job of dirt
pick-up.
1,
2.
3.
Unplugged at wall outlet.
Tripped circuit breaker/blown
fuse
at household
service panel.
Off/Floor/Carpet
switch not set to
Floor or Carpet.
1. Full or clogged dust bin.
2. Wrong pile height setting.
3. Worn agitator.
4. Clogged nozzle or bag holder.
5. Clogged
hose,
6. Hole in hose.
7,
8.
9.
10.
Hose not inserted fully
2.
3.
Motor protection system activated.
8.
Dirty filters.
9.
Suction control slide open.
10.
Plug in firmly, push Off/Floor/Carpet
switch to Floor or Carpet
Reset circuit breaker or replace fuse.
Push Off/Floor/Carpet switch to
Floor or Carpet (page 8).
1. Emptydust bin,, (page 15).
2. Adjust setting, (page 7).
3. Take to your nearest Sears
Service Center.
4. Check CLOG REMOVAL, (page 18).
5. Check for dogs, (page 18).
6. Take to your nearest Sears
Service Center.
7. Check hose connection
Check for dogs, (page 18).
Change filters, (page 17).
Close slide (page 10).
Cleaner picks up
1. Wrong pile height setting.
1. Adjust setting, (page 7).
moveable rugs or
Jushes too hard,
Light won't work,
1. Burned out light bulb.
1. Change light bulb, (page 19).
Agitator does not turn.
1. Off/Floor/Carpetselector in
1. Move selector to the Carpet position,
Off or Floor position.
(page 8).
2. Handle in full upright position.
2. Move handle from upright position
(page 8).
3. Agitator Overload tripped.
3. Reset Agitator Overload (page 12),
4. Thermal protector tripped.
4. Allow vacuum to cool, then reset
Thermal protector(page 12).
Performance indicator is
1. Full or clogged dust bin
1. Empty dust bin, (page 15)+
red.
2. Dirty filters.
2. Change filters, (page 17).
3. Clogged airflow passage.
3. Clear clog from airflow passage,
(page 18).
4. Certain attachment tools.
4. This is normal. Light should go off
when tool is removed.
Air flow restricted
1. Attachment use restricts air flow.
1. Check ATTACHMENTS, (page 9)
with attachment use.
Sound changes.
2. New carpet fuzz clogged air path.
2. Check CLOG REMOVAL and clean
hose, (page 18).
Dirt Sensor, some
1. Dirtyoptic cells.
1. Clean optic ceils, (page 13).
models, will not work.
21
Publicidad
Tabla de contenido
