Publicidad
Idiomas disponibles
Idiomas disponibles
- Make sure that the area in which you are cutting is free from
obstructions. Do not let the nose of the guide bar contact branch,
limb or any other obstruction while you are operating the unit.
- Maintain a firm grip, with both hands on the machine and position
your body and arm to allow you to resist kickback forces. Kickback
forces can be controlled by the operator, if proper precautions are
taken. Do not let go of the pruner.
- Do not over reach. This helps prevent unintended tip contact and
enables better control of the pruner in unexpected situations.
- Only use replacement bars and chains specified by the
manufacturer. Incorrect replacement bars and Chains can affect the
normal use of the machine.
- Sharpening the chain safely is a skilled task. Therefore the
manufacturer strongly recommends that a worn or dull chain is
replaced with a new one. The part number is available in the
product specification table in this manual.
• Do not use a ladder or unstable support. Always cut with both feet
on solid ground to prevent being pulled off balance.
• To protect yourself from electrocution, do not operate within
10m(32.8 ft) of overhead electrical lines.
• Beware of falling branches or those which rebound after hitting
the ground.
• Use extreme caution when cutting small-sized brush and saplings
because slender material may catch the saw chain and be whipped
toward you or pull you off balance.
• When cutting a limb that is under tension, be alert for spring back
so that you will not be struck when tension in wood fibers are
released.
10
Publicidad
