Costway GT3665DE Manual Del Usuario página 23

3. Assembly of the cutting head and Pole
f) Take out the Pole Assembly and the Cutting Head Assembly.
g) Unscrew the Shaft Coupling 3(2) by anti-clockwise direction and
pull out the Extension Pole 4 until the desired length and screw by
clockwise to lock the Shaft Coupling 3(2).
NOTE: the extended pole 4 should be longer than 15cm (5.9 inches)
h) Unscrew the Shaft Coupling 3(1) on Cutting Head by
anti-clockwise direction on handle. Make the pin on Aluminum Pole
align with the hole on the Cutting Head for next step.
i) Plug the extended Aluminum Pole into the Cutting Head. Now the
pin has been locked in the hole of handle and Cutting Head won't
come off.
j) Tighten the shaft coupling 3(4) by clockwise direction with screw.
At this step, the connection between Cutting Head and pole is
finished.
Fig f) Fig h)
Fig i) Fig j)
4. Cutting Operation:
a) Unscrew the Shaft Coupling 3(2) & 3(3) to pull out the Extension
Pole to desired length for proper cutting height. The machine is
designed to maximum cut 2.8M (9.1 FT ) height of branches.
23