DSC WTK5504 Manual Del Usuario página 8

No-Entry Arming
Home > More > Functions > Arming Modes > No Entry
This allows the system to be armed without an entry delay from zones that normally have one. An entry through any
zone will therefore create an instant alarm. To arm without an entry delay:
1. Check that the Ready indicator is on.
2. From the Home screen, press No Entry
"Arming with No-entry delay" appears on the screen. The system is now armed in Stay mode.
Silent Exit Delay
If the system is armed using the Stay Arm button or using the "No-Entry" Arming method, the audible progress annun-
ciation (keypad buzzer) is silenced and the exit time doubled for that exit period only (CP-01 versions only).
NOTE: For non CP-01 versions, Standard exit time is used.

Instant Stay Arming (for Impassa SCW9055/57 and Alexor PC9155)
Home > More > Functions > Arming Modes > Instant Stay Arming
Where programmed by the installer, this function key, when held down for 2 seconds, allows you to arm the system in
Stay mode instantly. No beeps will sound and there will be no exit delay.
NOTE: This is not enabled on CP-01 listed systems.
System Chime (Chime Enable/Disable)
Home > More > Functions > System Chime
Press the key to choose the setting opposite to the one currently in use. A brief message of either "Door Chime
Enabled" or "Door Chime Disabled" will appear to indicate the current setting. When chime is enabled, you can use
the Voice Chime button on the Home screen to select Voice Chime, Chime, or No Chime.
Quick Exit
Home > More > Functions > Quick Exit
If the system is armed and you need to exit, use the quick exit function to avoid disarming and rearming the system. To
activate this function, press Quick Exit. The "Quick Exit in Progress" screen appears and the voice prompt says,
"Quick exit in progress" followed by "Please exit now". You have 2 minutes to leave the premises through your exit
door. When the door is closed again the remaining exit time is cancelled.
Outputs
Home > More > Functions > Outputs
Your installer may have programmed these keys to perform other functions (reset sensors after an alarm, open your
garage door etc.) To activate these functions, press the appropriate option. See also Sensor Reset on page 13.
Clean Mode
Home > More > Functions > Clean Mode
Clean Mode allows the user to touch (i.e., clean) the screen without enabling or disabling any functions. The screen
will remain in this mode for 30 seconds, then return to the More Functions screen.
7
.
The verbal prompt announces "No-entry arming in progress" and
Figure 8 - Outputs