Keypad Configuration - DSC WTK5504 Manual Del Usuario

Setting an Access Code
1. Select "Set Access Code". A keypad screen is shown with the existing code. If there is no existing code,
"AAAA" (or AAAAAA for 6 digits) is shown.
2. Start to enter a new code. The code area will be cleared, and the new code will be shown. If the clear key is
pressed, the new code will be cleared, but the old code is not deleted by this action. Once the last digit is
entered the new code will have replaced the old code; no further action is required to save the code. If the
screen "times out" (goes grey or black) or you exit the screen without completing the new code, the previous
code will remain.
Proximity (Prox) Tag Enrollment and Use (WTK5504P keypad only)
Home > More > User Options > Access Code Prog [Master Code] > Select
User > User xx settings > Prox Tag Prog
Enrolling Proximity Tags
1. Press Prox Tag Programming.
2. Place the prox tag near the tag reader
"Tag Enrolled Successfully" will be displayed and the keypad will beep. If the proximity tag has been enrolled
previously, an error tone will sound. The screen will read "Duplicate Tag/User Code".
NOTE: Prox tags do not work on PowerSeries panels.
Erasing Prox Tags
Delete tags from the system when they are lost or no longer needed. To delete a proximity tag, the user code it is asso-
ciated with must be deleted.
1. Press More > User Options > Access Code Prog. [Master Code].
2. Use left and right arrow buttons to select the user number associated with the proximity tag to be deleted and
press Select.
3. Press Delete User and confirm by pressing Yes.
Replacing Existing Prox Tags
To keep the same user code and number, but enroll a new tag due to loss of the old one
1. Press Prox Tag Programming.
2. Confirm that you want to overwrite the existing tag by pressing Yes.
3. Place the prox tag near the tag reader
will be displayed and the keypad will beep.
User Options
Erasing an Access Code
To erase a code, select the code and choose Delete User. The system will delete the code immediately and the user will
be returned to select another code.

Keypad Configuration

Changing Brightness
Home > More > User Options > Keypad Config > Brightness
Use the slide bar to adjust brightness to the desired setting. To exit, press the Back or Home button.
Night Light Brightness Control
Home > More > User Options > Keypad Config > Brightness > Nightlight
You can use the slide bar to determine the brightness of the keypad "night light" that shines from the sides of the key-
pad. When this slider is in the position of darkest (left hand side of the slider), the night light feature will be disabled. If
the slider is all the way to the right, then the night light will be on as bright as possible.
1. Use the slide bar to select the desired brightness of the night light backlighting.
2. To exit press the Back or Home button.
9
at the top of the keypad to assign it to the user code. The message
at the top of the keypad. The message "Tag Enrolled Successfully"
Figure 10 - Keypad Configuration