Maintenance And Service - Dremel 3D45 Traducción De Las Instrucciones Originales

Problem
Filament is not extruding or sticking
to the build tape properly.
Dremel 3D45 froze before my
object started.
Support material does not break
away during cleaning and results
in decreased quality of the final
object.
Spaghetti mess at end of build.
Part only built halfway.
No filament coming out.
Extruder will not home.
Stringy or fraying plastic layers on
steep overhangs.
3D45 will not find my Wi-Fi
network.
3D45 will not connect to my
network.
3D45 will not retrieve a token.
Cloud slicer will not connect to
3D45 or shows "printer offline".
Token invalid.

MAINTENANCE AND SERVICE

Cause
This can be caused by the build
platform not being level with the
extruder head.
Dremel 3D45 may have received
conflicting commands.
Orientation of the part is not
optimized.
A layer of your object did not stick
properly, model was saved with
minimal surface area contacting the
build platform, or object was built
floating above the build platform
with no support selected.
Z-Gap offset may not be correct
and the extruder tip is not properly
spaced with the build platform.
Filament ran out.
Filament clogged during build.
Clogged extruder.
Filament not properly loaded.
Object overhangs are too far apart
or too steep (<45 degree angle).
Printer too far from wireless router.
Printer too far from wireless router.
Network password or SSID
incorrect.
Network password incorrect.
Network has a firewall.
3D45 not connected to network.
Verify the current 3D45 token using
"Tools/About" and retry.
30
Corrective Action
Leveling the build platform will align
the extruder head and ensure a
better object quality. Cancel your
object, clear build platform, level
the build platform, and restart the
object.
Turn power switch off, wait 30
seconds, and turn power switch on.
Reorient the position of the 3D file
in your slicing software to minimize
the support material or place the
support material on a non-critical
surface.
Use the preview feature in your
slicing software to see the first
layer height and position. Build with
supports when necessary.
Contact customer service on how to
calibrate the Z-Gap Offset.
Replace filament and resume build.
See "No filament coming out".
Contact customer service.
Try running a filament change
again to ensure the extruder gears
have properly caught the filament.
Contact customer service.
Build with supports.
Reposition 3D45 to be closer to
your router.
Connect to network with Ethernet.
Reposition 3D45 to be closer to
your router.
Re-enter your password/SSID or
verify your password with your
network owner.
Re-enter your password or verify
your password with your network
owner.
Enter network proxy information.
Check 3D45 network settings and
retry connection.
Use "Get new token" to generate a
new token and retry connection.
Note this will remove any users that
are sharing your printer.