DRILL-DRIVER
Chuck
Motor
GearTrain
NoLoadSpeed
Clutch
Maximum Torque
973.114170
3/8 in. Keyless
DC Motor 19.2 Volt
Two Speed
0-400 RPM (Low)
0-1400 RPM (High)
24 Positions
400 in.lbs
CHARGER
Rating
Charging Voltage
Charge Rate
BATTERY
PACK
Item No. 9 11041
(1425301)
12o V, 60 Hz, AC only
7.2 - 24 Volt
1 Hour
Item No. 9 11375
(1323513
or 1310715)
KNOW
YOUR
DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
KEYLESS
CHUCK
Your drill-driverhas a keyless chuck that allows you to hand
tighten or release drill bit in the chuck jaws.
SWITCH
To turn your drill-driver ON, depress the switch trigger.
Release switch trigger to turn your drill-driver OFF.
SWITCH
LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
VARIABLE
SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
TWO SPEED
GEAR TRAIN
Your drill-driver has a two speed gear train designed for
drilling or driving at HI or LO speeds. A slide switch is
located on top of your drill to select either HI or LO speed.
FORWARD/REVERSE
SELECTOR
(DIRECTION
OF ROTATION SELECTOR)
Your drill-driver has a forward/reverse selector located
above the switch trigger.
WRIST
STRAP
A wrist strap is provided to reduce the chances of
dropping your drill-driver. Place one hand through the wrist
strap when carrying tool.
BIT STORAGE
When not in use, bits provided with your drill-driver can be
placed in the storage area located on the bottom of the
motor housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the top and end of the motor housing.
,_
WARNING:
If any parts are missing, do not operate
your drill-driveruntil the missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
7