Descargar Imprimir esta página

Sony STR-DH550 Guía De Referencia página 5

Ocultar thumbs Ver también para STR-DH550:

Publicidad

Idiomas disponibles

Idiomas disponibles

"WALKMAN"
and "WALKMAN"
logo are
registered
trademarks
of Sony Corporation.
MICROVAULT
is a trademark
of Sony
Corporation.
MHL, Mobile
High-Definition
Link and the
MHL Logo are trademarks
or registered
trademarks
of MHL Licensing,
LLC.
Precautions
On safety
Should
any solid
object
or liquid
fall into
the cabinet,
unplug
the receiver
and have it
checked
by qualified
personnel
before
operating
it any further.
On
power
sources
• Before
operating
the receiver,
check
that
the operating
voltage
is identical
with
your local power
supply.
The operating
voltage
is indicated
on the
nameplate
on the back of the receiver.
• The unit is not disconnected
from the AC
power
source
(mains)
as long as it is
connected
to the wall outlet,
even
if the
unit itself has been turned
off.
• If you are not going to use the receiver
for
a long time,
be sure to disconnect
the
receiver
from
the wall outlet.
To
disconnect
the AC power
cord (mains
lead),
grasp the plug itself;
never
pull the
cord.
• (USA and Canada
models
only)
One blade of the plug is wider
than the
other for the purpose
of safety
and will fit
into the wall outlet
only one way. If you
are unable
to insert the plug fully into the
outlet,
contact
your dealer.
• The AC power cord (mains
lead) must be
changed
only
at a qualified
service
shop.
On heat
buildup
Although
the receiver
heats up during
operation,
this is not a malfunction.
If you
continuously
use this receiver
at a large
volume,
the cabinet
temperature
of the top,
side and bottom
rises considerably.
To
avoid burning
yourself,
do not touch
the
cabinet.
On placement
• Place the receiver
in a location
with
adequate
ventilation
to prevent
heat
buildup
and prolong
the life of the
receiver.
• Do not place the receiver
near heat
sources,
or in a place
subject
to direct
sunlight,
excessive
dust, or mechanical
shock.
• Do not place anything
on top of the
cabinet
that might block
the ventilation
holes and cause
malfunctions.
• Do not place
the receiver
near equipment
such as a TV, VCR, or tape deck.
(If the
receiver
is being used in combination
with
a TV, VCR, or tape deck, and is
placed
too close
to that equipment,
noise
may result,
and picture
quality
may
suffer.
This is especially
likely
when
using
an indoor
antenna
(aerial).
Therefore,
we recommend
using an
outdoor
antenna
(aerial).)
• Use caution
when placing
the receiver
on
surfaces
that have been specially
treated
(with wax, oil, polish,
etc.) as staining
or
discoloration
of the surface
may result.
On operation
Before
connecting
other equipment,
be sure
to turn off and unplug
the receiver.
On cleaning
Clean the cabinet,
panel,
and controls
with
a soft cloth slightly
moistened
with a mild
detergent
solution.
Do not use any type of
abrasive
pad, scouring
powder,
or solvent,
such as alcohol
or benzine.
5 GB

Publicidad

loading