Briggs & Stratton 020223 Manual Del Propietário página 6

ASSEMBLY
IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
• Remove the parts bag, accessories, and inserts included
with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
• Remove pressure washer from carton.
Carton Contents
Items in the carton include:
• Main Unit
Handle
• Goggles
• High Pressure Hose
• Spray Gun
• Adjustable Nozzle Extension
• Parts Bag (which includes the following):
• Hose Fittings
• Quick Connects
• Maintenance Kit
• Owner's Manual
• Engine Manual
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• "L" Hooks (2)
• Plastic Knobs (2)
If parts are missing or damaged, contact the local Briggs &
Stratton service center.
PREPARING PRESSURE
WASHER FOR USE
To prepare your pressure washer for operation, you
will need to perform these tasks:
1. Attach handle to main unit.
2. Add oil to engine crankcase.
BSPP 2400 PSI Pressure Washer
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and pump.
5. Connect water supply to pump.
6. Attach nozzle extension to spray gun.
Attach Handle to Unit
1. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 2).
Figure 2 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of the
unit and attach a plastic knob from inside of unit
(Figure 3).Tighten by hand.
Figure 2 — Secure Handle
3. Insert one "L" hook through hole just above billboard
on left side of handle (viewing from front of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 4).Tighten by hand.
Figure 4 — Attach "L" Hooks to Handle
Spray Gun Hook
4. Insert other "L" hook through hole just below
billboard on right side of handle (viewing from front of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 4).Tighten by hand.
6
Handle
Handle
Supports
Hose Hook