GE 23 Serie Manual Del Propietario E Instalación página 5

About the temperaturecontrols. GEAppliances.com
J
%..........---
The temperature controls are preset in the factory at 37°F for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
To change the temperature, press and release the
WARMER or COLDER pad.
Tile SETlight will come
on and tile display will show tile set teml)eramre.
To change the temi)eratm'e, trip either the
WARMER or COLDER pad tmdl the desired
temperatm'e is displayed. ]?.ef'rigerator temperatm'es
can be ac!justed between 34°F and 44°F and the
fl'eezer teInl)eratures can be ac!iusted between
-6°F and +6°E
Once the desired temperattu'e has been set,
the temperature display will return to the actual
reflJgerator and fl'eezer teml)eratm'es afier 5
seconds. Several a(!itlsunents ma)' be reqtfired.
Each time you a(!iust controls, allow 24 horn's fin" the
refl-igerator to reach tile teml)eratm'e you have set.
Toturn the cooling system off, tnp the WARMER i;ad
fin" either tile reli-igerator or tile fl'eezer tmtil tile
display shows OFF.To turn the unit back on, press the
COLDERpad fin" either the refligerator or fl'eezer
The SETlight will illuminate on the side you
selected. Then press the COLDERpad again (on the
side where the SETlight is ilhmfinated) and it will
go to the preset points of O°Ftbr the fl'eezer and
37°Fior the refiigeratox: Setting either or both
controls to OFFsmps cooling in both the fi'eezer
and refiigerator compartments, but does not shut
off electrical power to the refl'igerat(n:
Performance Air FlowSystem
The Perfimmmce _d_=glow System is designed to
maximize temperatm'e control in the refligerator
and fl'eezer compartments. This tmique special
teature consists of the :Mr Tower along the back
wall of the refligerator and
the :Mr Tmmel
on the
bottom portion of tile fl'eezer rear wall. Placing fi)od
in fi'ont of the louvers on these components will not
affect I)erl(mnance. Although
the :Mr Tower and
the ?dr Tunnel can be removed, doing so will affect
temperature pedimnance. (For remox_fl
instructions, on-line, 24 horns a day, contnct us at
GEAl)pliances.com or call 800.GE.CARES. In
Canada, contnct us at geappliances.ca or call
1.800.361.3400.)