cecotec READYWARM 2000 POWER CEILING Manual De Instrucciones página 10

Always unplug the device when not in use.
- The heater must be installed at least 1.8 m above the floor
and 0.5 m from the ceiling, roof and both side walls.
- The heater must not be oriented with the heating element
towards the ceiling. The heater must face the area to be
heated.
- Warning: do not cover the device in order to avoid overheating.
- Do not use the appliance in case of visible damage.
- Do not attempt to repair or adjust any electrical or mechanical
function of this appliance. The appliance contains no user
serviceable parts. Maintenance or repairs should only be
carried out by a qualified electrician. Attempting to repair
the unit yourself will void the warranty.
- Do not use the appliance in direct sunlight, near heat sources,
in humid environments or in places near water or other
liquids, such as bathrooms, showers or swimming pools.
- This product should not be left outdoors exposed to the
elements for long periods of time.
- To avoid a possible fire, do not block the air outlets.
- Always place the appliance with the plug in an accessible
position and avoid using extension cords, as they may
overheat and cause a potential fire hazard.
- Always make sure that the heater is plugged into a suitable
socket that has been tested for outdoor use.
- To turn the heater off, turn the switch to the OFF position
and then disconnect the plug from the socket. Do not pull on
the plug to disconnect the appliance.
- Warning: this heater is not equipped with a device to control
the room temperature. Do not use this heater in small rooms
if the people in the room are unable to get out by themselves;
supervise them.
- Check exterior walls for damaged areas before installing the
heater.
10
READYWARM 2000 POWER CEILING