Installation
Instructions
UNPACKING
THE WASHER
WARNING:
Rec, cle dest o,: the
and plastic bags after tile washer is unpacked.
Make
materials
inaccessible
to children.
Children
might use
them fi)r play. Cations
covered
with rugs, bedspreads
or plastic sheets can become
airtight
chambe_
causing
suffocation.
1. Grit
and
remove
tile top and bottom
packaging
straps.
2. \._q/ile it is in tile carton,
careflllly lay the washer on its
side. DO NOT lay tile washer on its ti'ont or back.
3. Tm'n down tile bom)m
flaps--remove
all base
packaging,
including
the cardboard,
SQTOfi)am base
and stvrofi)am
tub support
(inserted
in center
of base).
NOTE:
If you axe installing
a pedestaJ,
proceed
to the
installation
hastructio_s
that come with the pedestal.
4. Carefldlv
returi_ tile washer to an upright
position
and
i'elllOVe
tile
cai'[on,
5. Careflfllx move tile washer to within
4 teet
( 122 cm) of
tile final location.
6. Remove
tile fi)llowing fl'om tile back side (ff tile washer:
4 bolts
4 plastic space_
(including
rubber
grommets)
4 power
cord retaine_
NOTE: Failure to remove tile shipping braces can cause
the washer to become sexereE tmbalanced.
Save
all bolts
for
future
use.
NOTE:
If you must transport
tile washer at a later date,
you must reinstall
tile shipping
support
hardware
to
prevent
shipping
damage.
Keep tile hardware
in tile
plastic bag provided.
16