GE GBVH5140 Manual Del Propietario E Instalación página 19

Installation Instructions
INSTALLING THE WASHER (cont.)
7. Attach lJ-shaI)ed hose guide to tile end of tile drain
hose. Place tile hose in a laundry tub or standpipe
and secure it with the cable tie provided in the
enclosure package.
NOTE: If the drain hose is placed in a standpipe
without tbmfing a U shape, a siphoning action could
occm: There m ust be an air gap aro/md tile drain hose.
A snug hose fit can also cause a siphoning action.
CableTie / CableTie ._r
I
CableTie
8. Plug tile power cord into a grounded outlet.
NOTE: Check to be sure the power is off at a
circuit breaker/fuse box belm'e plugging tile power
coFd into an outlet.
9. Turn on tile power at a circuit breaker/fllse box.
10. Read the rest of this Owner's Manual. It contains
valuable and hell)tiff infi)rmation that will save vou
time and Illonev.
11. Before starting the washer, check to make sure:
Main power is turned on.
U_ITile washer is plugged in.
Tile water fimcets are turned on.
U_lThe refit is level and all fimr leveling legs are firefly
on tile floor.
U_ITile shil)ping
suppo_l
hardware is removed
and saved.
Tile drain hose is i)roperly tied up.
There are no leaks at tile timcet, drain line
or washen
12. Run tile washer through a complete cycle. Check
fi)r water leaks and proper operation.
1:3. If your washer does not operate, please review
the Before You Call For Service section belm'e
calling t(n" service.
14. Place these instructions in a location near the
washer fin" flmu'e reference.
REPLACEMENT PARTS
If replacement parts are needed fin" your washer; they
can be ordered in tile United States by visiting our
_,Vebsite at ge.com or by calling 800.GE.CARES.
19