How To Store The Heater; Troubleshooting - Shizuoka Seiki Co. VAL6KBE1S Manual Del Usuario

5

How to Store the Heater

CAUTION
When you store the heater, please disconnect the power plug from the AC outlet and store it indoors
where it is less humid.
• Do not store the fuel over summer months for use during next heater season. Using old fuel could damege the heater.
6

Troubleshooting

■ When you face problems on your heater, please refer to this check-
table before consulting your service shop.
In case satisfactory results do not come out through referring to the table, or you have problems not de-
scribed in this table, please contact your dealer. While consulting him, please describe the problem you
have, together with type and serial number of your heater.
(For finding the heater's serial number, please refer to page 14.)
Phenomenon
The heater does not start.
(The lamp does not light
on.)
The heater does not start.
(The lamp is lit.)
The heater does not ignite.
The flame goes out during
the operation.
If the following phenomenon takes place, it is not an irregular trouble. Please check again
before consulting your service shop.
Phenomenon
When used for the first time, smoke or smell
comes out of the heater.
At the time of ignition or shut-down of the
heater, noise comes from the burner section.
• When you store the heater or hold it unused for a long time, please make sure that the fuel
tank is empty, for preventing a leakage of fuel and fire.
Observations
Possible Cause
Power cord is not connected with an
AC outlet. Power supply is cut off.
Blown fuse
Safety devices are working.
No fuel in the fuel tank.
There is water in the fuel tank.
Fuel filter element is clogged.
Nozzle is clogged
Wrong or foul fuel is used.
Flame monitor is dirty.
Fuel filter element is clogged.
Because fuel is burning together with dusts, etc. This phenomenon will disap-
pear after a short while.
Noise is caused by expansion or shrinkage of the burner section due to
temperature's up and down. This is not irregular.
Remedy
Please connect the power cord with an AC outlet, and
check the power supply.
Replace fuse with a new one.
(Please refer to page 12.)
Please confirm if "Flame Monitor" is exposed to any type of light
(sunlight or electric lamp, etc.), and remove the heater to pre-
vent the radiation disk from detecting any type of light directly.
Please pour fuel into the tank.
Please clean up the tank and fill it with fresh/clean fuel.
Check well the filter element and replace it with a new one.
Replace nozzle with a new one.
Please clean up the fuel tank and fill it with fresh/new
fuel.
Please clean up the Flame Monitor
(Please refer to page 10).
Please check the filter element and replace it with a
new one.
Explanation
(Please refer to page 12.)
11