Assembly Instruction - Shizuoka Seiki Co. VAL6KBE1S Manual Del Usuario

ASSEMBLY INSTRUCTION

ASSEMBLY INSTRUCTION
The unit is packaged without having the safety guard, visor and wheel parts
assembled.
Be sure to assemble the safety guard and the visor properly before the unit is used.
Follow the instruction below to assemble the safety guard, visor and wheel parts
in the correct order.
No.2
No.2
Put the main structure on the wheel frame
and fasten them with the screws provided.
Note: Screws which are used for temporary joint in
packing are not needed for assembling.
No.1
No.1
Put the shaft through the shaft plate, then
mount the wheels, washers and cutter-pins.
CAUTION
Do not use the unit without the safety
guard to prevent from the accident.
No.3-1
No.3-1
Safety
guard
Hook
No.3-1
No.3-1
At first the safety guard must
be slid under the hook.
No.3-3
No.3-3
Finally, the visor must be fastened with the
screws provided on both sides.
Closeup
No.3-2
No.3-2
No.3-2
No.3-2
Then the safety guard must
be fastened with the screws
provided on both sides.
Visor
1