How To Use; Preparation For The Operation - Shizuoka Seiki Co. VAL6KBE1S Manual Del Usuario

!8 Flame Monitor
!9 Electric Overload
System (Fuse)
3

How to Use

3-1. Preparation for the Operation

DANGER
CAUTION
■ Refueling
• Make sure that the tank inlet filter (in the fuel tank) is free of dirt/dusts, etc. If the filter is filled up with dirt/dusts, take out
the filter and wash it with kerosene. Do not pour back into the fuel tank the kerosene used for washing, to avoid troubles.
• Please use "kerosene" or "diesel" and do not use poor quality or foul kerosene, to have no troubles at all.
1
Remove the fuel cap and insert a handy suc-
tion pump into the fuel tank.
2 Watch the fuel gauge while refueling.
When the gauge reaches the maximum level,
stop refueling.
■ Connecting the Power Supply
1 Make sure that the operating switch is "OFF",
then plug the power plug into the AC power
outlet.
2 Make sure a grounded power pin or connec-
tion is used.
6
Description of Safety Devices
This automatically extinguishes the flame when ignition fails or flame goes
out during the operation. This monitor, when detects any irregularity be-
fore ignition, automatically extinguishes the flame.
Operating Condition: Misfire lamp flashes and Post-Purge continues for three
This shuts off the power supply when excessive electric current passes
through, due to irregular trouble of the devices.
Operating Condition: The whole operation stops.
• Never use highly flammable fuel like gasoline, to avoid fire.
• Always make sure that the heater is turned off before refueling. Fire can occur.
• Make sure the heater is powered with the electrical voltage and frequency specified on
specification label. Not doing so can result in fire, electrical shock and/or damage.
• Make sure a grounded power pin or connection is used. Operating the heater without a
proper ground may result in electrical shock.
• When disconnecting the power cord, always pull on the plug to unplug the cord. Do not
place excessive force on the cord by bending or pulling. Doing so may damage the cord,
resulting in fire or electrical shock.
Observations
(3) minutes.
3
Tighten well the fuel cap, and wipe off any
spilt fuel.
Power Plug
AC Outlet
Connect