Descargar Imprimir esta página

Costway NP10397 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
Installation
Instructions
1
Place the product on a soft ground at
least 2 meters away from any other
objects (such as fences, trees, water
sources, hanging branches, clotheslines
or wires). Make sure the area around the
product is safe. Check whether there are
sharp objects on the ground, and keep
the blower (air pump) and power cord
away from water and moisture.
3
Place the blower (air pump) where it will
not inhale dust or leaves, and keep the
blower (air pump) and power cord away
from children and water. Note: Please
make sure the power supply is safe and
reliable. During use, the blower (air
pump) should remain on and continue to
inflate. After stretching the air pipe,
position the blower (air pump) at the
end of the air pipe. Wind one end of the
tube around the blower (air pump), blow
out the air after tying. The inflation tube
should be straight and not twisted. If
necessary, adjust the position of the
blower (air pump). Then use ground
piles to firmly fix the blower (air pump)
on the ground.
04
2
The slide should not face the sun as this
can make children dizzy while using the
product.
4
Please fix the product correctly, and be sure to fix the product with ground stakes
before use. In order to prevent overturning during the game, please push the pile
firmly into the ground, and regularly check whether the ground pile is firm. Ground
piles should be flush with the ground or buried in the ground to reduce the risk of
tripping. Please ensure that the product is fully inflated before children enter the
playground. Using this product when inflated or excessively deflated may cause
product instability and may cause serious injury. Since the product is kept inflated
by a constant air flow, air leakage from the joint is normal and necessary, so the
product will not over-expand.
Disassembly
Instructions
Make sure that after all children leave the product, turn off the blower (air pump),
remove the inflation tube, unplug the power cord of the blower (air pump), remove
the ground pile, and store the blower (air pump) in a dry place for future use. When
the product is not in use, do not put the product and the blower (air pump) in the rain.
Maintenance
Outdoor products are easy to wear and require proper maintenance. When the fabric
is found to be invalid, fragile or damaged, it must be repaired in time, and the
provided patch can be used to repair it. To repair, deflate thoroughly and make sure
the surface is dry. Cut the patch to a size suitable for the repair. Apply glue on both
the repair patch and the damaged surface, let the glue dry for 30 seconds, and then
stick the patch on the surface. Allow to dry at least 4 hours before using. Store the
product and blower in a dry environment when not in use.
EN
05

Publicidad

loading