Hoover ST71 ST20011 Manual De Instrucciones página 6

in cleaner body, once complete then lock container in place by pushing container bin
handle down until the latch connects with the main body of the cleaner, you will hear a
click when fully connected. This is the opposite to step 1.
To Access the exhaust filter Located on the base of the cleaner.
1. Unlock the exhaust filter door by pressing two buttons and pulling outward from main
cleaner. [16]
2. Remove the filter pack from recess by pulling the ring-pull of exhaust filter. [17]
3. Gently tap and wash the filter unit. Do not use hot water or detergents. Remove excess
water from the filter and leave to dry fully before using. [18,19]
4. Reassemble the filter pack once it is fully dry and refit to the cleaner by inserting it back
into the location and pushing it fully home.
5. Lock the exhaust filter cover by pressing the edge which has the clips, you will hear a
click once the exhaust filter door fits into place.
IMPORTANT: Do not use the product without the filter pack fitted.
USER CHECK LIST
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• There is no section called "Cleaning the cyclonic unit"?
• Check if the auger is blocked. If so, refer to "Unblocking the compaction system".
• If the display panel shows nothing except the power indicator lights, but suction is still low:
A. Do the filters need cleaning? If so refer to "Cleaning the washable filters".
B. Check if there is any other blockage in the system. Use a rod or pole to remove any
blockage from the fixed tube or flexible hose.
C. Check pre motor filter is fitted correctly and filter cover is entirely closed.
D. Check if the Dust Container is fitted into place.
E. Check if the cyclonic unit needs to be cleaned. Refer to "Cleaning the multi cyclone".
F. Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset.
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Pre Motor & Exhaust Filter Kit
Complete Flexible Hose
Hard Floor Extra Nozzle
Carpet Extra Nozzle
Parquet Extra Nozzle
Pet Hair Remover Nozzle
Hoover Service
Should you require service, spares and consumables at any time, please contact your
local Hoover Service Office.
Quality
Hoover's factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
4
U59 35601649
D204E 35601652
G227EE 35601653
G228EE 35601654
G89PC 35600659
J51 35601163
GB