Publicidad
Idiomas disponibles
Idiomas disponibles
HFC user manual
5. EQUIPMENT OPERATION
The refrigeration units must be coupled to a refrigeration system to enter into operation. The
refrigeration compressors, of hermetic/ semi-hermetic type, are fed by a single-phase or three-
phase electrical network and compress a refrigerant fluid of non-halogenated type, HFCs.
6. TRANSPORT OF EQUIPMENT
The transfer of the equipment can be done with means for lifting and transport.
The loading, transport and unloading operation should only be carried out by qualifi ed
personnel for handling lifting and securing systems
Take special care that no one passes the maneuver, lifting and transport area, to avoid
possible accidents during the transfer of the load.
Pay special attention to the lifting speed of the refrigeration unit so that it does not
cause oscillations with danger of falling and the inclination of the blades to be adequa-
te according to the previous image.
7. EQUIPMENT INSTALLATION
7.1
Indications
The machine is supplied with the safety instructions and warnings as summarized in this docu-
mentation.
7.2
Positioning and location of the machine
The choice of the place of installation and location of the machine, as well as the external electri-
cal connections, are the responsibility of the Client and / or Installer, never of the Manufacturer.
The position and place of installation of the refrigeration unit must meet the following general
guidelines:
• Allow the correct use of the equipment and facilitate an agile maintenance in safety con-
ditions, providing that the installation respects the minimum free spaces for the opening
of the equipment.
• Do not exceed 85% humidity.
• Keep away from heat sources.
• Allow continuous air renewal.
24
Publicidad
