Hingedown Back (Optional); Push Handles - Küschall ULTRA-LIGHT Manual Del Usuario

Ultra-Light
Adjusting the backrest cover
1. Remove the backrest cushion A.
2. Loosen the Velcro® tapes B on the rear of the backrest cover
by simply pulling on them.
3. Tighten or loosen the tapes as required then reattach them.
WARNING!
Risk of tipping
If the bands are set very loose, the tipping point of
your wheelchair is changed for the worse.
– Ensure that the bands are set correctly.
IMPORTANT!
– Do not overtighten the bands; this is to ensure
that the geometry of the wheelchair is not
changed.
IMPORTANT!
– Only ever tighten the bands when the wheelchair
is unfolded.
12

3.4 Hingedown back (optional)

The back can be hinged down and straightened up in both the
folded and unfolded state.
Hinging down the back
1. To hinge down the back, grip the strap on the back of the
wheelchair and pull it upwards.
2. At the same time, push the upper edge of the back forwards.
Straightening up the back
1. To straighten up the back, grip the upper edge of the back
and fold it upwards.
IMPORTANT!
– Do not fold and unfold the wheelchair when the
back is hinged down.

3.5 Push handles

IMPORTANT!
– Always check the push handles before using the
wheelchair, as to whether the hand grips are
secure, cannot be turned and cannot be pulled
off.
1583566-A