Craftsman professional INCREDI-PULL 316.794802 Manual Del Operador página 6

The completed blower tube should look like Figure 5.
Secure the Throttle Cables
Place a zip tie around the elbow tube and the throttle cables (Fig. 6) as
shown, making sure not to crimp the cables.
Elbow Tube
Hose Cmamp
Throttme Cables
Upper Blower Tube
Throttme Grip
Lower Blower Tube
Nezzme
On/Off Switch
_----- Cruise Controm
Zip Tie
Zip Tie
Fig. 6
Adjusting the Throttle Grip
1. Move the throttle grip to a location on the upper blower tube that is
comfortable for you (Fig. 7).
Throttle Grip
Upper Blower Tube
2.
Fig. 7
Using a Torx T-20 Torx screwdriver, tighten the two screws at the
bottom of the throttle grip (Fig. 8).
Fig. 5
_ ARNING:
To avoid serious personal injury, make sure that the
blower tubes are locked in place or firmly installed.
Fig. 8