Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING
THE SUSPENSION
SYSTEM
1.
Place the unit's shoulder supports over the shoulders while the unit is
behind you.
2.
Close the suspension
system's waist support by sliding the waist
support clips together (Fig. 17, A).
A
Fig. 17
NOTE:
Make sure the weight of the unit is supported
on the hips by the
waist support (Fig. 18, A).
A
A
9.
B
Fig. 18
If weight is not on hips, loosen the shoulder supports (Fig. 19, A) and
pull the waist support handle (Fig. 18, B) to tighten.
Adjust until the
unit's weight rests on the hips.
A
B
A
Fig. 19
4.
Pull the shoulder support handles to tighten the shoulder supports
(Fig.
17, B).
Releasing
the Suspension
System
1.
To loosen the shoulder supports,
pull up on bottom tab of the shoulder
support buckles (Fig. 19, A).
2.
Squeeze the top and bottom of the waist support clips to release the
waist support (Fig. 19, B).
HOLDING
THE BLOWER
safety glasses at all times when operating this unit. Wear a face
mask or dust mask in dusty locations.
Before operating the unit, stand in the operating position (Fig. 20). Check
for the following:
• Operator
is wearing proper clothing, such as boots, safety glasses or
goggles, ear/hearing
protection,
gloves, long pants and long sleeve shirt.
If the conditions are dusty, the operator is wearing a dust mask or face mask.
The unit is in good working condition.
The tubes are in place and secure.
Fig. 20
OPERATING
TiPS
the unit, make sure blower tubes are in place before you operate
the unit.
Assure the unit is not directed at anybody or any loose debris before
starting the unit.
Verify that the unit is in good working condition.
Make sure the tubes are
in place and secure.
Always hold the unit securely when operating.
To reduce the risk of hearing loss associated
with sound level(s), hearing
protection
is required.
Operate power equipment
only at reasonable
hours--not
early in the
morning or late at night when people might be disturbed.
Comply with
times listed in local ordinances.
Usual recommendations
are 9:00 am to
5:00 pm, Monday through Saturday.
• To reduce noise levels, limit the number of pieces of equipment
used at
any one time.
• To reduce noise levels, operate power blowers at the lowest possible
speed to do the job.
Check your equipment before operation,
especially the muffler, air intakes
and air filters.
Use rakes and brooms to loosen debris before blowing.
• In dusty conditions,
slightly dampen surfaces or use a mister attachment
when water is available.
Conserve water by using power blowers instead of hoses for many lawn
and garden applications,
including areas such as screens, patios, grills,
porches, and gardens.
Watch out for children, pets, open windows or freshly washed cars, and
blow debris safely away.
• Use the full blower nozzle extension so the air stream can work close to
the ground.
• Clean up after using blowers and other equipment.
Dispose of debris
appropriately.
Use the cruise control (Fig. 15) to keep the trigger depressed while
operating to make continuous
operation easier.
APPLICATIONS
1
Use the blower for trees, shrubs, flower beds and hard-to-clean
areas.
2.
Use the unit around buildings and for other normal cleaning procedures.
3.
Use the blower around walls, overhangs,
fences and screens.
Publicidad
