Power Dynamics PDZM800 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
FRONT PANEL
1. MICROPHONE INPUT
Balanced combo-jack microphone inputs, supporting both XLR
and 6.3mm jack.
2. ASSIGNMENT 1-3
Press to assign the microphone channel to a specific master
channel (1-3).
3. MICROPHONE VOLUME
Rotate to adjust the microphone volume level.
4. LED INDICATORS
LED level indicators, showing the microphone channel level within
a range of -20db to +9db.
5. EQUALIZER
Three-way equalizer for microphone channels (HI, MID, LOW).
6. ON AIR
Press to turn on/off the microphone. When turned on, the LED will
be illuminated.
7. DB LEVEL
Rotate to adjust the talkover level.
8. TIME
Rotate to adjust the talkover response time.
9. TALKOVER
Press to turn talkover on/off. When turned on, the LED will be illuminated.
When talkover is turned on, the volume of channels 1-5 will be lowered when microphone input is detected.
10. INPUT SELECTOR
Press to select input source. The LED of the corresponding input source will be illuminated when turned on.
11. ASSIGNMENT 1-3
Press to assign the corresponding channel to a specific master channel (1-3).
12. CUE
Press to allow for prefader listening of the input channel ahead of the respective channel fader via
headphones. When turned on, the LED will be illuminated to indicate that the channel is being monitored.
13. FADER
Slide to adjust the volume level of the corresponding channel signal. Use these faders to adjust the balance
between the various channels.
14. LED INDICATORS
LED level indicators, showing the channel level within a range of -20db to
+9db.
15. VOLUME
Rotate to adjust the volume level of main channel 1-3.
16. EQUALIZER
Three-way equalizer for master channels (HI, MID, LOW).
17. REC ASSIGNMENT 1-3
Press to assign a master channel (1-3) to both recording outputs.
18. REC OUTPUT
RCA stereo output for recording purposes. The recording level is
independent of the output level controls.
19. CUE/PGM
Rotate to select the monitoring signal for the headphones output.
In CUE position, the prefader level of the input channel of which the CUE
button is pressed is monitored.
In PGM position, the currently playing music program is monitored.
In middle position, a mixed signal is both is monitored.
3