Makita HR2300 Manual De Instrucciones página 8

the O symbol. Turn the bit to the desired angle.
Rotate the action mode changing knob to the
Then make sure that the bit is securely held in place by
turning it slightly.
010728
Depth gauge
The depth gauge is convenient for drilling holes of
uniform depth.
1
3
010716
Press the lock button on the grip base in the direction of
arrow shown in the figure and with the lock button being
pressed insert the depth gauge into the hex. hole in the
grip base
2
010717
At this time, the depth gauge needs to be inserted so
that its toothed side is directed to the toothed side of hex
hole marking on the grip base as shown in the figure.
010718
1. Grip base
2
2. Lock button
3. Depth gauge
1. Toothed side of
1
hex hole
marking on the
grip base
2. Toothed side of
the depth gauge
1. Lock button
1
Adjust the depth gauge to the desired depth by moving it
symbol. back and forth while pressing the lock button. After the
adjustment, release the lock button to lock the depth
gauge.
1
010719
NOTE:
Inserting the depth gauge with its toothed side not
•
directed to the toothed side of hex hole marking on
the grip base as shown in the figure does not allow
the depth gauge to be locked.
Dust cup
1
010731
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in the
figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
006386
There is another type of dust cup (accessory) which
helps you prevent dust from falling over the tool and on
yourself when performing overhead drilling operations.
Installing or removing the dust cup
1
011506
8
1. Toothed side of
2
hex hole
marking on the
grip base
2. Toothed side of
the depth gauge
1. Dust cup
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
1. symbol
2
2. Grooves
3. Dust cup
3