Kenmore 10478 Manual De Uso página 27

CONVERSION
INSTRUCTIONS
,
Put the new orifice into the orifice removal
tool (B), and then insert the tool into the
burner opening and tighten the new orifice
into the valve.
Repeat this step for all five burners.
Make sure you are using the correct
orifice, which is marked "1.37". (Fig. 60)
,
Rotate the air shutter opening from the
LP setting to the NG setting.
LP: 1/4" open
NG: 1/6" to 1/8" open
(Fig. 61)
I
Air shutter opening to adjust
Fig. 61
I
Side Burner Conversion
1. Loosen the side burner screws to expose
the side burner valve.
Insert the tool onto the valve and unscrew
Orifice from end of valve. Put the new
orifice into the orifice removal tool and
tighten the new orifice into the valve.
Make sure you are using the correct orifice,
which is marked "1.31". (Fig. 62)
Loosen
Fig. 62
2. Engage burner tube over valve as shown
and tighten the loosened screws .(Fig. 63)
Fig. 63
27