Publicidad
Idiomas disponibles
Idiomas disponibles
PD 2G 18.0-EC HD / DD 2G 18.0-EC HD
Symbols used in this manual
WARNING!
Denotes impending danger. Non- observance
of this warning may result in death or
extremely severe injuries.
CAU TION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
N OTE
Denotes application tips and important
information.
Symbols on the power tool
V
Volts
/min
Rotation rate
To reduce the risk of injury, read the
operating instructions!
Disposal information for the old
machine (see page 17)!
For your safety
WARNING!
Before using the power tool, please read the
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged.
The percussion drill driver may be used only
as intended,
in perfect working order.
Faults which impair safety must be repaired
immediately.
Intended use
The cordless drill driver/hammer drill is
intended.
– for commercial use in industry and trade,
– for inserting and releasing screws
– for drilling in wood, metal, ceramic and
plastic,
– for impact drilling in brick, masonry and
stone (only for PD 2G 18.0-EC HD).
Safety instructions for percussion
drill driver
WARNING!
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury. Save all
warnings and instructions for future reference.
■ Hold the power tool by insulated
gripping surfaces, when performing an
operation where the cutting accessory or
fastener may contact hidden wiring. The
cutting accessory or fastener contacting a
"live" wire may make exposed metal parts
of the power tool "live" and could give the
operator an electric shock.
Safety instructions when using
long drill bits:
■ Never operate at higher speed than the
maximum speed rating of the drill bit.
At higher speeds, the bit is likely to bend if
allowed to rotate freely without contacting
the workpiece, resulting in personal injury.
■ Always start drilling at low speed and
with the bit tip in contact with the
workpiece. At higher speeds, the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece, resulting
in personal injury.
■ Apply pressure only in direct line with
the bit and do not apply excessive
pressure. Bits can bend causing breakage
or loss of control, resulting in personal
injury.
■ Use auxiliary handles if these are
supplied with the power tool. The loss of
control may result in injuries.
13
Publicidad
