Flex PD 2G 18.0-EC HD Instrucciones De Funcionamiento Originales página 16

■ Align the hole of the belt clip 17 and bit
bracket 19 with the threaded hole on the
base of the tool (see figure D).
■ Insert the fastening screw 18 and securely
tighten the screw with a screwdriver (not
included).
Strap fixing
■ Strap fixing is provided to attach a wrist
strap (not included) in order to reduce the
chances of dropping your tool. Wrap the
strip around your hand when carrying the
tool (see figure E).
Fitting/removing the auxiliary handle
CAUTION!
Use auxiliary handle if these are supplied with
the power tool. The loss of control may result
in injuries (see figure F).
■ Remove the battery pack from the tool.
■ Place the direction preselector switch 2 in
the center lock position.
■ Loosen the auxiliary handle 12 by turning
the handle counterclockwise.
■ Align the raised portion on the auxiliary
handle with the grooves on gearbox of
the drill/driver, and then put the auxiliary
handle onto the tool.
■ Hand-tighten the handle by turning the
handle clockwise.
■ To remove the handle, loosen the auxiliary
handle counterclockwise and remove it.
Install and remove bits
(see figure G)
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch 2
to the middle position.
■ Lock the trigger switch 1 OFF on the tool
by placing the direction preselector switch
in the center position.
■ Grip the power tool firmly with one hand
and turn the chuck with the other hand.
– Turn counterclockwise to open the
chuck further.
– Turn clockwise to close the chuck.
■ Insert the tool.
■ Close the chuck fully.
NOTE
Carry out a test run to check that the tool is
chucked in the centre.
16
PD 2G 18.0-EC HD / DD 2G 18.0-EC HD
WARNING!
The bit may be hot after prolonged use. Use
protective gloves when removing the bit from
the tool, or first allow the bit to cool down.
Direction preselection (see figure H)
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
Move the direction preselector switch 2 to the
required position:
■ Right: counterclockwise (remove screws,
release screws)
■ Left: clockwise (drill, insert screws, tighten
down screws)
■ Middle: switch-on interlock (tool change,
when working on the power tool)
Operating mode (see figure I)
CAUTION!
Change the operating mode only when the
power tool is stopped.
■ Move the operating mode turning dial 4 to
the required position.
: Drilling
: Screwing
: Impact drilling
Only for PD 2G 18.0-EC HD
Torque preselection (see figure J)
CAUTION!
Change the torque only when the power tool
is stopped.
Move the torque setting turning dial 5 to the
required position.
Speed preselection (see figure K)
CAUTION!
Change the speed only when the power tool
is stopped.
Move the speed selector switch3 to the
required stage:
■ Low speed, high torque
■ High speed, low torque
Anti-kickback
■ The anti-kickback feature enables better
control of the drill and improves user's
comfort. The drill automatically turns off in