Publicidad
5. Align the switch with the wall anchors and secure
the switch to the wall using the appropriate
screws for the wall anchors.
Using the Screw Hooks
Use the following instructions to mount the DIS-200G
on a wall using the screw hooks on the underneath
of the switch:
6. Mark two points on the surface where you wish
to mount the switch 60 mm apart.
7. Drill holes on the marks and insert wall anchors
appropriate for the material of the wall.
8. Insert screws into the wall anchors, leaving
roughly 4.50 mm of distance from the wall for
the switch to be mounted.
9. Mount the DIS-200G on the screws using the
screw hooks on the underneath of the switch.
Figure 8
4
Figure 7
Mounting the Switch in a Rack
The DIS-200G can be mounted in a standard 19"
server rack by using the included rack mounting
brackets (optional).
Use the following instructions to install the switch
in a rack:
1. Attach the included mounting brackets to each
side of the DIS-200G using the provided screws.
Figure 9
2. Use the screws that were provided with the rack
to install the DIS-200G in the rack.
Figure 10
Grounding the Switch
To use the DIS-200G safely, it needs to be grounded.
Please complete these steps before powering-on
the switch.
Use the following instructions to ground the
DIS-200G:
1. Remove the grounding screw from the top of the
DIS-200G and place the grounding cable lug ring
on top of the grounding screw opening.
2. Insert the grounding screw back into the
grounding screw opening and use a screwdriver
to tighten the grounding screw, securing the
grounding cable to the DIS-200G.
3. Attach the terminal lug ring at the other end of the
grounding cable to an appropriate grounding source.
Publicidad
