Publicidad
Step 19
2 people are required for this step. Carefully turn the unit over onto its front side as
shown. Assure that the unit is square. Distance from corner to corner must be equal
as shown.
Align the upper back panel with the
top of the unit. Align the side edges with
the edge of the left upper end panel (A) and
right upper end panel (B) and nail straight into the
back edges as shown.
IMPORTANT! DO NOT HAMMER IN THE NAILS IN THE CENTER ROW UNTIL LOWER BACK
PANEL IS IN PLACE AS THE BACK PANELS WILL OVERLAP.
Align the lower back panel with the bottom edge of part (Q). Align the side edges with the
edge of the lower left and lower right panels (C) & (D) and nail straight into the back edges
as shown. Following this step the unit should be stood upright.
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS UNIT AND MUST
BE INSTALLED PROPERLY.
ameriwoodhome.com
13
(x30)
#A21110
1st
B
D
27
13
2nd
Q
You
Tube
Publicidad
